Cisco TelePresence Administrator's Manual page 405

Reference material
Alternates Cluster Name: <S: 0,128>
The fully qualified domain name used in SRV records that address this VCS cluster, for example
"cluster1.example.com". The name can only contain letters, digits, hyphens and underscores.
Warning: if you change the cluster name after any user accounts have been configured on this VCS, you may
need to reconfigure your user accounts to use the new cluster name. Refer to the Clustering and peers section
for more information.
Example: xConfiguration Alternates Cluster Name: "Regional"
Alternates ConfigurationMaster: <1..6>
Specifies which peer in this cluster is the master, from which configuration will be replicated to all other peers. A
cluster consists of up to 6 peers, including the local VCS.
Example: xConfiguration Alternates ConfigurationMaster: 1
Alternates Peer [1..6] Address: <S: 0, 128>
Specifies the IP address of one of the peers in the cluster to which this VCS belongs. A cluster consists of up to 6
peers, including the local VCS. This must be a valid IPv4 or IPv6 address.
Example: xConfiguration Alternates 1 Peer Address: "10.13.0.2"
Applications ConferenceFactory Alias: <S:0,60>
The alias that will be dialed by the endpoints when the Multiway feature is activated. This must be pre-configured
on all endpoints that may be used to initiate the Multiway feature.
Example: xConfiguration Applications ConferenceFactory Alias: "multiway@example.com"
Applications ConferenceFactory Mode: <On/Off>
The Mode option allows you to enable or disable the Conference Factory application.
Default: Off
Example: xConfiguration Applications ConferenceFactory Mode: Off
Applications ConferenceFactory Range End: <1..65535>
The last number of the range that replaces %% in the template used to generate a conference alias.
Default: 65535
Example: xConfiguration Applications ConferenceFactory Range End: 30000
Applications ConferenceFactory Range Start: <1..65535>
The first number of the range that replaces %% in the template used to generate a conference alias.
Default: 65535
Example: xConfiguration Applications ConferenceFactory Range Start: 10000
Applications ConferenceFactory Template: <S:0,60>
The alias that the VCS will tell the endpoint to dial in order to create a Multiway conference on the MCU. This
alias must route to the MCU as a fully-qualified SIP alias
Example: Applications ConferenceFactory Template: "563%%@example.com"
Applications External Status [1..10] Filename: <S:0,255>
XML file containing status that is to be attached for an external application.
Example: xConfiguration Applications External Status 1 Filename: "foo.xml"
Cisco VCS Administrator Guide (X7.2) Page 405 of 498