Cisco TelePresence Administrator's Manual page 246

You must use a different Template on each VCS in your network that has the Conference Factory
n
application enabled. If your VCS is part of a cluster, the Template must be different for each peer in the
cluster.
The alias generated by the Template must be a fully-qualified SIP alias and must route to the MCU. The
n
MCU must be configured to process this alias. No other special configuration is required on the MCU in
order to support the Conference Factory application.
SIP mode must be set to On
n
Conference Factory application to function. If you want to be able to initiate calls to the Conference Factory
from H.323 endpoints, you must also set H.323 mode to On
and ensure that H.323 <-> SIP interworking mode is set to Registered only or On
Protocols > Interworking).
See Multiway deployment guide
(endpoints, MCUs and VCSs) in order to use Multiway in your deployment.
Cisco VCS Administrator Guide (X7.2)
(VCS configuration > Protocols > SIP >
for full details on how to configure individual components of your network
Configuration) for the
(VCS configuration > Protocols >
(VCS configuration >
Applications
H.323),
Page 246 of 498