Cisco TelePresence Administrator's Manual page 415

Video communication server
Hide thumbs Also See for TelePresence:
Table of Contents

Advertisement

Reference material
IP QoS Mode: <None/DiffServ>
Specifies the type of QoS (Quality of Service) tags to apply to all signaling and media packets.
None: no specific QoS tagging is applied.
DiffServ: puts the specified Tag value in the TOS (Type Of Service) field of the IPv4 header or TC (Traffic Class)
field of the IPv6 header.
Note: you must restart the system for any changes to take effect.
Default: None
Example: xConfiguration IP QoS Mode: DiffServ
IP QoS Value: <0..63>
The value to be stamped onto all signaling and media traffic routed through the VCS. You must restart the system
for any changes to take effect.
Default: 0
Example: xConfiguration IP QoS Value: 16
IP RFC4821 Mode: <Auto/Enabled/Disabled>
Determines when RFC4821 Packetization Layer Path MTU Discovery is used by the VCS network interface.
Enabled: Packetization layer MTU probing is always performed.
Auto: Disabled by default, enabled when an ICMP black hole is detected.
Disabled: Packetization layer MTU probing is not performed.
Default: Disabled
Example: xConfiguration IP RFC4821 Mode: Disabled
IP Route [1..50] Address: <S: 0, 39>
Specifies an IP address used in conjunction with the Prefix Length to determine the network to which this route
applies.
Example: xConfiguration IP Route 1 Address: "128.168.0.0"
IP Route [1..50] Gateway: <S: 0, 39>
Specifies the IP address of the Gateway for this route.
Example: xConfiguration IP Route 1 Gateway: "192.168.0.0"
IP Route [1..50] Interface: <Auto/LAN1/LAN2>
Specifies the LAN interface to use for this route. Auto: The VCS will select the most appropriate interface to use.
Default: Auto
Example: xConfiguration IP Route 1 Interface: Auto
IP Route [1..50] PrefixLength: <0..128>
Specifies the number of bits of the IP address which must match when determining the network to which this
route applies.
Default: 32
Example: xConfiguration IP Route 1 PrefixLength: 16
IP V6 Gateway: <S: 0, 39>
Specifies the IPv6 gateway of the VCS. You must restart the system for any changes to take effect.
Example: xConfiguration IP V6 Gateway: "3dda:80bb:6::9:144"
Cisco VCS Administrator Guide (X7.2)
Page 415 of 498

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Telepresence x7.2

Table of Contents