Cisco TelePresence Administrator's Manual page 419

Reference material
Policy AdministratorPolicy Service TLS Verify Mode: <On/Off>
Controls X.509 certificate checking and mutual authentication between this VCS and the policy service. When
enabled, the server's FQDN or IP address, as specified in the address field, must be contained within the server's
X.509 certificate (in either the Subject Common Name or the Subject Alternative Name attributes).
Default: On
Example: xConfiguration Policy AdministratorPolicy Service TLS Verify Mode: On
Policy AdministratorPolicy Service UserName: <S: 0,30>
Specifies the user name used by the VCS to log in and query the remote policy service.
Example: xConfiguration Policy AdministratorPolicy Service UserName: "user123"
Policy FindMe CallerID: <FindMeID/IncomingID>
Determines how the source of an incoming call is presented to the callee.
IncomingID: displays the address of the endpoint from which the call was placed.
FindMeID: displays the FindMe ID associated with the originating endpoint's address.
Default: IncomingID
Example: xConfiguration Policy FindMe CallerId: FindMeID
Policy FindMe Mode: <Off/On/ThirdPartyManager>
Configures how the FindMe application operates.
Off: disables FindMe.
On: enables FindMe.
ThirdPartyManager: uses an off-box, third-party FindMe manager.
Default: Off
Example: xConfiguration Policy FindMe Mode: On
Policy FindMe Server Address: <S: 0, 128>
Specifies the IP address or Fully Qualified Domain Name (FQDN) of the remote FindMe Manager.
Example: xConfiguration Policy FindMe Server Address: "userpolicy.server.example.com"
Policy FindMe Server Password: <S: 0, 82>
Specifies the password used by the VCS to log in and query the remote FindMe Manager. The maximum
plaintext length is 30 characters, which will then be encrypted.
Example: xConfiguration Policy FindMe Server Password: "password123"
Policy FindMe Server Path: <S: 0, 255>
Specifies the URL of the remote FindMe Manager.
Example: xConfiguration Policy FindMe Server Path: "service"
Policy FindMe Server Protocol: <HTTP/HTTPS>
Specifies the protocol used to connect to the remote FindMe Manager.
Default: HTTPS
Example: xConfiguration Policy FindMe Server Protocol: HTTPS
Policy FindMe Server UserName: <S: 0, 30>
Specifies the user name used by the VCS to log in and query the remote FindMe Manager.
Example: xConfiguration Policy FindMe Server UserName: "user123"
Cisco VCS Administrator Guide (X7.2) Page 419 of 498