Cisco TelePresence Administrator's Manual page 408

Reference material
Authentication ADS Mode: <On/Off>
Indicates if the VCS should attempt to form a relationship with the AD.
Default: Off
Example: xConfiguration Authentication ADS Mode: On
Authentication ADS SPNEGO: <Enabled/Disabled>
Indicates if SPNEGO (Simple and Protected GSSAPI Negotiation Mechanism) is used when the client (the VCS)
authenticates with the server (the AD domain controller).
Default: Enabled
Example: xConfiguration Authentication ADS SPNEGO: Enabled
Authentication ADS SecureChannel: <Auto/Enabled/Disabled>
Indicates if data transmitted from the VCS to an AD domain controller is sent over a secure channel.
Default: Auto
Example: xConfiguration Authentication ADS SecureChannel: Auto
Authentication ADS Workgroup: <S: 0,15>
The workgroup used when the VCS joins the AD domain.
Example: xConfiguration Authentication ADS Workgroup: "corporation"
Authentication LDAP AliasOrigin: <LDAP/Endpoint/Combined>
Determines how aliases are checked and registered.
LDAP: the aliases presented by the endpoint are checked against those listed in the LDAP database.
Endpoint: the aliases presented by the endpoint are used; any in the LDAP database are ignored.
Combined: the aliases presented by the endpoint are used in addition to any listed in the LDAP database.
Default: LDAP
Example: xConfiguration Authentication LDAP AliasOrigin: LDAP
Authentication Password: <S: 0, 215>
The password used by the VCS when authenticating with another system. The maximum plaintext length is 128
characters, which is then encrypted. Note: this does not apply to traversal client zones.
Example: xConfiguration Authentication Password: "password123"
Authentication UserName: <S: 0, 128>
The username used by the VCS when authenticating with another system. Note: this does not apply to traversal
client zones.
Example: xConfiguration Authentication UserName: "VCS123"
Bandwidth Default: <64..65535>
Sets the bandwidth (in kbps) to be used on calls managed by the VCS in cases where no bandwidth has been
specified by the endpoint.
Default: 384
Example: xConfiguration Bandwidth Default: 384
Cisco VCS Administrator Guide (X7.2) Page 408 of 498