Kyocera TASKalfa 181 Service Manual page 121

Section Description
Document 75
processor An original jam in the
original switchback
section
78
Document processor
cover open
Finisher 80
Jam between the fin-
isher and machine
81
Finisher paper entry
nonarrival jam
83
Finisher paper entry
jam
84
Finisher eject jam
Conditions
During original switchback in the duplex mode, the origi-
nal switchback switch (OSBSW) does not turn on within
specified time of the original conveying motor (OCM)
turning on.
The document processor or document processor top
cover is opened during original feeding.
The original set switch (OSSW) or original size length
switch (OSLSW) turns on when starting the original paper
feed.
Paper ejection is not output from the machine to the doc-
ument finisher within specified time of the paper convey-
ing switch (PCSW) turning on.
The paper conveying switch (PCSW) is not turned on
even if a specified time has elapsed after the machine
eject signal was received.
The paper conveying switch (PCSW) does not turn off
within specified time of its turning on when paper is con-
veyed to the process table from the paper conveying unit.
The paper conveying switch (PCSW) is not turned on
within the specified time when paper is ejected to the fin-
isher tray from the process table.
The paper conveying switch (PCSW) does not turn off
within specified time of the its turning on when paper is
ejected to the finisher tray from the process table.
2KJ/2KH
Specified time
10700 pulses
-
15 s
2598 ms
1869 ms + Paper
length
2570 ms
1869 ms + Paper
length
1-4-7