Checking The Paper Ejection To Optional Devices; Setting The Maintenance Cycle; Checking/Clearing The Maintenance Count - Kyocera TASKalfa 181 Service Manual

Maintenance
item No.

Checking the paper ejection to optional devices

U249
Description
Eject paper to the optional ejection device. When the job separator or the built-in finisher is connected, this
operation cannot be run.
Purpose
To check that paper is ejected properly to the optional ejection device.
Method
1. While pressing the feedshift switch by your hand, press the start key.
Paper transfer operation starts.
Completion
Press the stop/clear key. The screen for selecting a maintenance item No. is displayed.

Setting the maintenance cycle

U250
Description
Displays and changes the maintenance cycle.
Purpose
To check and change the maintenance cycle.
Method
1. Press the start key. The currently set maintenance cycle is displayed.
Setting
1. Change the setting using the numeric keys.
Description
Maintenance cycle
2. Press the start key. The value is set.
Clearing
1. Press the reset key.
2. Press the start key. The count is cleared.
Completion
Press the stop/clear key. The screen for selecting a maintenance item No. is displayed.

Checking/clearing the maintenance count

U251
Description
Displays, clears and changes the maintenance count.
Purpose
To check the maintenance count. Also to clear the count during maintenance service.
Method
1. Press the start key. The maintenance count is displayed.
Setting
1. Select [COUNT] using the cursor up/down keys.
2. Change the count using the numeric key.
3. Press the start key. The count is set.
Clearing
1. Select [CLEAR] using the cursor up/down keys.
2. Press the start key. The count is cleared.
Completion
Press the stop/clear key. The screen for selecting a maintenance item No. is displayed.
Description
Setting range
0 to 9999999
2KJ/2KH
Initial setting
150000
1-3-45