Detaching And Refitting The Fuser Thermistor - Kyocera TASKalfa 181 Service Manual

(6) Detaching and refitting the fuser thermistor

Follow the procedure below to replace the fuser thermistor.
Procedure
1. Separate the right and left fuser unit (see
page 1-5-49).
2. Remove the heat roller (see page 1-5-55).
3. Remove the screw and remove the fuser
thermistor.
4. Replace the fuser thermistor and refit all the
removed parts.
Caution
Restore the fuser thermistor wire to its origi-
nal correct position.
After refitting the heat roller, push the roller
lightly to check that the detection surface of
the fuser thermistor comes in contact with
the roller.
Screw
Right fuser unit
Figure 1-5-95
2KJ/2KH
Fuser thermistor
1-5-57