Registration Status; Registrations By Device - Cisco TelePresence Administrator's Manual

Registration status

Registrations by device

The Registrations by device
registered with the VCS, and allows you to remove a device's registration. If the VCS is part of a cluster, all
registrations across the cluster are shown.
Note that an H.323 device can register with more than one alias; in such cases this page will show only one
alias and (when present) one E.164 number for that device. Note also that a single device can support both
the SIP and H.323 protocols; in such a case the SIP registration and the H.323 registration will appear as
separate entries on this page.
The following information is displayed:
Field Description
Name For H.323 devices, this is one of its aliases. If the device has registered with more than one alias, this
will be (in order of preference) its H.323 ID, URI or email address. For MCUs and Gateways this will be
its alias or, if it has not registered an alias, one of its prefixes. For SIP devices, this is its SIP AOR.
E164 For H.323 devices that have registered one or more E.164 numbers, the first will be shown here. For
SIP devices this will always be blank because they cannot register E.164 numbers.
Type Indicates the nature of the registration. This will most commonly be Endpoint, MCU, Gateway, or SIP
UA.
Protocol Indicates whether the registration is for a SIP or H.323 device.
Creation The date and time at which the registration was accepted.
time If an NTP server has not been configured, this will say Time not set.
Address For H.323 devices this is its RAS address, and for SIP UAs it is the Contact address presented in the
REGISTER request.
Peer Identifies the cluster peer to which the device is registered.
Clicking on a device's Name or E164 number takes you to the
For a list of all aliases currently registered with the VCS, see the
Unregistering a device
Click Unregister to remove the selected registrations.
Note that:
if your VCS is part of a cluster you have to be logged into the peer to which the device is registered to be
n
able to unregister it
removing a registration does not prevent the same device from automatically re-registering
n
Filtering the list
To limit the list of registrations, enter one or more characters in the Filter field and click Filter. Only those
registrations that contain (in any of the displayed fields) the string you entered will be shown.
To return to the full list of registrations, click Reset.
Cisco VCS Administrator Guide (X7.1)
page (Status > Registrations > By
Overview and status information
device) lists each device currently
Registrations details page for that device.
Registrations by alias page.
Page 30 of 479