Cisco TelePresence Administrator's Manual page 420

Reference material
Zones LocalZone SubZones MembershipRules Rule [1..3000] Type: <Subnet/AliasPatternMatch>
The type of address that applies to this rule.
Subnet: assigns the device if its IP address falls within the configured IP address subnet.
AliasPatternMatch: assigns the device if its alias matches the configured pattern.
Example: xConfiguration Zones LocalZone SubZones MembershipRules Rule 1 Type: Subnet
Zones LocalZone SubZones SubZone [1..1000] Authentication Mode:
<DoNotCheckCredentials/TreatAsAuthenticated/CheckCredentials>
Controls how the VCS authenticates incoming messages from this subzone and whether they are subsequently
treated as authenticated, unauthenticated or are rejected. The behavior varies for H.323 messages, SIP
messages that originate from a local domain and SIP messages that originate from non-local domains. See the
Administrator Guide for further information.
Default: DoNotCheckCredentials
Example: xConfiguration Zones LocalZone SubZones SubZone 1 Authentication Mode:
DoNotCheckCredentials
Zones LocalZone SubZones SubZone [1..1000] Bandwidth PerCall Inter Limit: <1..100000000>
Specifies the bandwidth limit (in kbps) on any one call to or from an endpoint in this subzone (applies only if
Mode is set to Limited).
Default: 1920
Example: xConfiguration Zones LocalZone SubZones SubZone 1 Bandwidth PerCall Inter
Limit: 1920
Zones LocalZone SubZones SubZone [1..1000] Bandwidth PerCall Inter Mode:
<Limited/Unlimited/NoBandwidth>
Determines whether there is a limit on the bandwidth for any one call to or from an endpoint in this subzone.
NoBandwidth: no bandwidth available. No calls can be made to or from this subzone.
Default: Unlimited
Example: xConfiguration Zones LocalZone SubZones SubZone 1 Bandwidth PerCall Inter Mode:
Limited
Zones LocalZone SubZones SubZone [1..1000] Bandwidth PerCall Intra Limit: <1..100000000>
Specifies the bandwidth limit (in kbps) for any one call between two endpoints within this subzone (applies only if
the mode is set to Limited).
Default: 1920
Example: Zones LocalZone SubZones SubZone 1 Bandwidth PerCall Intra Limit: 1920
Zones LocalZone SubZones SubZone [1..1000] Bandwidth PerCall Intra Mode:
<Limited/Unlimited/NoBandwidth>
Determines whether there is a limit on the bandwidth for any one call between two endpoints within this subzone.
NoBandwidth: no bandwidth available. No calls can be made within this subzone.
Default: Unlimited
Example: xConfiguration Zones LocalZone SubZones SubZone 1 Bandwidth PerCall Intra Mode:
Limited
Zones LocalZone SubZones SubZone [1..1000] Bandwidth Total Limit: <1..100000000>
Sets the total bandwidth limit (in kbps) of this subzone (applies only if the mode is set to Limited).
Default: 500000
Example: xConfiguration Zones LocalZone SubZones SubZone 1 Bandwidth Total Limit: 500000
Cisco VCS Administrator Guide (X7.1) Page 420 of 479