Cisco TelePresence Administrator's Manual page 372

ID Title
25005 Restart required Telnet service has been changed,
25006 Restart required Dual Network Interfaces option key
25007 Restart required QoS settings have been changed,
25008 Restart required Port configuration has been
25009 Restart required Ethernet configuration has been
25010 Restart required IP configuration has been
25011 Restart required HTTPS service has been changed,
25013 IP configuration
mismatch
25014 Configuration
warning
25015 Restart required SSH service has been changed,
25016 Ethernet speed
not
recommended
25017 Restart required HTTP service has been changed,
25018 Port conflict
25019 Verbose log
levels
configured
Cisco VCS Administrator Guide (X7.1)
Description
however a restart is required for
this to take effect
has been changed, however a
restart is required for this to take
effect
however a restart is required for
this to take effect
changed, however a restart is
required for this to take effect
changed, however a restart is
required for this to take effect
changed, however a restart is
required for this to take effect
however a restart is required for
this to take effect
IP protocol is set to both IPv4 and
IPv6, but the system does not have
an IPv6 gateway defined
IP protocol is set to both IPv4 and
IPv6, but the VCS does not have
any IPv6 addresses defined
however a restart is required for
this to take effect
An Ethernet interface speed setting
has been negotiated to a value
other than 1000Mb/s full duplex or
100Mb/s full duplex; this may result
in packet loss over your network
however a restart is required for
this to take effect
One or more ports have been
configured for use by more than
one service
One or more modules of the
Support Log have been set to a
level of Debug or Trace
Solution
Restart the system
Restart the system
Restart the system
Restart the system
Restart the system
Restart the system
Restart the system
Configure IP settings
Configure IP settings
Restart the system
Configure Ethernet parameters
Restart the system
Review the port configuration on the
Inbound Ports and Local VCS Outbound Ports
pages
Ensure that all modules of the
Support Log are set to a level of Info, unless
advised otherwise by your support
representative
Reference material
Severity
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Local VCS Warning
Network Log or Warning
Page 372 of 479