Cisco TelePresence Administrator's Manual page 283

Field Description
Password The password to be used, along with
the Username, when logging into
this account.
You must confirm any new or
modified password.
FindMe Specifies if the account is for an
type individual person or a group of
people, and affects how calls are
diverted when endpoints in the
user's primary list are busy.
Individual: calls immediately divert if
any primary endpoint is busy.
Group of people: calls immediately
divert only if all primary endpoints
are busy.
You can control general FindMe behavior, including whether users are allowed to add their own devices, on
the Configuring FindMe page.
Principal devices (Starter Pack)
The Principal devices section is used to specify the principal devices that are associated with the FindMe
user and to enable provisioning for those devices. This section only displays if the Starter Pack option key is
installed.
Principal devices are devices assigned to the user by the system administrator and cannot be deleted by the
FindMe user. Note that users can add other, non-principal, devices to their FindMe profiles.
To assign a principal device, select On for the relevant device type. The page will then display the URI that
will be assigned for that user and device type. You can assign as many devices as required.
The device URI is based on a combination of the Username, FindMe ID and device type. It takes the format
<username>.<device type>@<domain portion of FindMe ID>.
For example, if the Username is Alice.Smith and the FindMe ID is asmith@example.com, then the
URI for an E20 device would be alice.smith.e20@example.com.
Each selected device is automatically provisioned (with bandwidth limits and phone book information, for
n
example) when that device registers to the VCS.
You can specify an additional principal device by setting Other device to On and then specifying the
n
required URI of the device. If required, you can add further non-principal devices by clicking
the Edit user account
Note that the VCS only sends provisioning information to the pre-configured device types (Movi, E20 and so
on). Other principal devices added by the administrator or any other devices added by the FindMe user are
not provisioned by the VCS.
If device authentication using a local database is enabled, authentication credentials for the provisioned
devices must also be set up in the local authentication database. The credential name must be the same as
account username and the credential password must be the same as the password configured on the
provisioned devices.
Cisco VCS Administrator Guide (X7.1)
Usage tips
FindMe users can change their password after they have
logged in. Note that passwords are case sensitive, and that
the password fields are not shown if remote authentication is
enabled.
If the Starter Pack option key is installed all FindMe IDs are
created as Individual accounts.
page.
Maintenance
Edit user from
Page 283 of 479