Cisco TelePresence Administrator's Manual page 441

AllowListDelete
Deletes an entry from the Allow List.
AllowListId(r): <1..2500>
The index of the entry to be deleted.
Example: xCommand AllowListDelete AllowListId: 2
Boot
Reboots the VCS.
This command has no parameters.
Example: xCommand boot
CheckBandwidth
A diagnostic tool that returns the status and route (as a list of nodes and links) that a call of the specified type and
bandwidth would take between two nodes. Note that this command does not change any existing system
configuration.
Node1(r): <S: 1, 50>
The subzone or zone from which the call originates.
Node2(r): <S: 1, 50>
The subzone or zone at which the call terminates.
Bandwidth(r): <1..100000000>
The requested bandwidth of the call (in kbps).
CallType(r): <Traversal/NonTraversal>
Whether the call type is Traversal or Non-traversal.
Example: xCommand CheckBandwidth Node1: "DefaultSubzone" Node2: "UK Sales Office"
Bandwidth: 512 CallType: nontraversal
CheckPattern
A diagnostic tool that allows you to check the result of an alias transform (local or zone) before you configure it on
the system. Note that this command does not change any existing system configuration.
Target(r): <S: 1, 60>
The alias you want to use to test the pattern match or transform.
Pattern(r): <S: 1, 60>
The pattern against which the alias is compared.
Type(r): <Exact/Prefix/Suffix/Regex>
How the pattern string must match the alias for the pattern behavior to be applied.
Behavior(r): <Strip/Leave/Replace/AddPrefix/AddSuffix>
How the alias is modified.
Replace: <S: 0, 60>
The text string to use in conjunction with the selected Pattern behavior.
Example: xCommand CheckPattern Target: "john.smith@example.net" Pattern: "@example.net"
Type: "suffix" Behavior: replace Replace: "@example.com"
DefaultLinksAdd
Restores links between the Default Subzone, Traversal Subzone and the Default Zone.
This command has no parameters.
Example: xCommand DefaultLinksAdd
Cisco VCS Administrator Guide (X7.1)
Reference material
Page 441 of 479