Cisco TelePresence Administrator's Manual page 422

Reference material
Zones LocalZone Traversal H323 TCPProbe RetryCount: <1..65534>
Sets the number of times traversal-enabled endpoints registered directly with the VCS will attempt to send a TCP
probe to the VCS.
Default: 5
Example: xConfiguration Zones LocalZone Traversal H323 TCPProbe RetryCount: 5
Zones LocalZone Traversal H323 TCPProbe RetryInterval: <1..65534>
Sets the frequency (in seconds) with which traversal-enabled endpoints registered directly with the VCS will
send a TCP probe to the VCS.
Default: 2
Example: xConfiguration Zones LocalZone Traversal H323 TCPProbe RetryInterval: 2
Zones LocalZone Traversal H323 UDPProbe KeepAliveInterval: <1..65534>
Sets the interval (in seconds) with which a traversal-enabled endpoint registered directly with the VCS will send
a UDP probe to the VCS once a call is established, in order to keep the firewall's NAT bindings open.
Default: 20
Example: xConfiguration Zones LocalZone Traversal H323 UDPProbe KeepAliveInterval: 20
Zones LocalZone Traversal H323 UDPProbe RetryCount: <1..65534>
Sets the number of times traversal-enabled endpoints registered directly with the VCS will attempt to send a UDP
probe to the VCS.
Default: 5
Example: xConfiguration Zones LocalZone Traversal H323 UDPProbe RetryCount: 5
Zones LocalZone Traversal H323 UDPProbe RetryInterval: <1..65534>
Sets the frequency (in seconds) with which traversal-enabled endpoints registered directly with the VCS will
send a UDP probe to the VCS.
Default: 2
Example: xConfiguration Zones LocalZone Traversal H323 UDPProbe RetryInterval: 2
Zones LocalZone TraversalSubZone Bandwidth PerCall Limit: <1..100000000>
Specifies the bandwidth limit (in kbps) applied to any one traversal call being handled by the VCS (applies only if
the mode is set to Limited).
Default: 1920
Example: xConfiguration Zones LocalZone TraversalSubZone Bandwidth PerCall Limit: 1920
Zones LocalZone TraversalSubZone Bandwidth PerCall Mode: <Limited/Unlimited/NoBandwidth>
Determines whether there is a limit on the bandwidth of any one traversal call being handled by the VCS.
NoBandwidth: no bandwidth available. No traversal calls can be made.
Default: Unlimited
Example: xConfiguration Zones LocalZone TraversalSubZone Bandwidth PerCall Mode: Limited
Zones LocalZone TraversalSubZone Bandwidth Total Limit: <1..100000000>
Specifies the total bandwidth (in kbps) allowed for all traversal calls being handled by the VCS (applies only if
the mode is set to Limited).
Default: 500000
Example: xConfiguration Zones LocalZone TraversalSubZone Bandwidth Total Limit: 500000
Cisco VCS Administrator Guide (X7.1) Page 422 of 479