Cisco TelePresence Administrator's Manual page 129

Setting Description
Zone profile Determines how the zone's advanced settings are configured.
Default: uses the factory defaults.
Preconfigured profiles: alternatively, choose one of the preconfigured
profiles to automatically use the appropriate settings required for
connections to that type of system. The options include:
Microsoft Office Communications Server 2007: (see
n
Lync 2010 and VCS deployment guide
Note: from VCS software version X7 you are recommended to use the
Microsoft OCS/Lync B2BUA
Microsoft OCS/Lync Server.
Cisco Unified Communications Manager (see
n
Communications Manager with VCS using a SIP trunk deployment guide
for more information)
Nortel Communication Server 1000
n
Cisco Advanced Media Gateway (see
n
Cisco AM GW and VCS deployment guide
Infrastructure device (typically used for non-gatekeeper devices such as
n
an MCU)
Custom: allows you to configure each Advanced setting individually. These
settings are listed in the remainder of this table below.
Monitor peer Specifies whether the VCS monitors the status of the zone's peers. If
status enabled, H.323 LRQs and/or SIP OPTIONS are periodically sent to the
peers. If a peer fails to respond, that peer is marked as inactive. If all peers
fail to respond the zone is marked as inactive.
Call signaling Specifies how the VCS handles the signaling for calls to and from this
routed mode neighbor.
Auto: signaling is taken as determined by the Call routed mode
configuration >
Always: signaling is always taken for calls to or from this neighbor,
regardless of the Call routed mode configuration.
Note that calls via traversal zones or the B2BUA always take the signaling.
Automatically Determines what happens when the VCS receives an H.323 search,
respond to destined for this zone.
H.323
Off: an LRQ message is sent to the zone.
searches
On: searches are responded to automatically, without being forwarded to
the zone.
H.323 call Specifies the port on the neighbor to be used for H.323 calls to and from this
signaling port VCS.
This setting only applies if Automatically respond to H.323 searches is On
(which includes when the Infrastructure device profile is selected), as the
search process normally identifies which call signaling port to use.
Cisco VCS Administrator Guide (X7.1)
for more information)
to route SIP calls between the VCS and a
Microsoft OCS 2007, Lync 2010,
Calls) configuration.
Microsoft OCS 2007,
Cisco Unified
for more information)
(VCS
Zones and neighbors
Default Applicable
to
Default Neighbor
zones
DNS
zones
Yes Neighbor
zones
Auto Neighbor
zones
Off Neighbor
zones
1720 Neighbor
zones
Page 129 of 479