Cisco TelePresence Administrator's Manual page 445

LinkDelete
Deletes a link.
LinkId(r): <1..3000>
The index of the link to be deleted.
Example: xCommand LinkDelete LinkId: 2
ListPresentities
Returns a list of all the presentities being watched by a particular subscriber.
Subscriber(r): <S:1, 255>
The URI of the subscriber who is watching.
Example: xCommand ListPresentities Subscriber: "john.smith@example.com"
ListSubscribers
Returns a list of all subscribers who are watching for the presence information of a particular presentity.
Presentity(r): <S:1, 255>
The URI of the presentity being watched.
Example: xCommand ListSubscribers Presentity: "mary.jones@example.com"
Locate
Runs the VCS's location algorithm to locate the endpoint identified by the given alias, searching locally, on
neighbors, and on systems discovered through the DNS system, within the specified number of 'hops'. Results
are reported back through the xFeedback mechanism, which must therefore be activated before issuing this
command (e.g. xFeedback register event/locate).
Alias(r): <S: 1, 60>
The alias associated with the endpoint you wish to locate.
HopCount(r): <0..255>
The hop count to be used in the search.
Protocol(r): <H323/SIP>
The protocol used to initiate the search.
SourceZone: <S: 1, 50>
The zone from which to simulate the search request. Choose from the Default Zone (an unknown remote
system), the Local Zone (a locally registered endpoint) or any other configured neighbor, traversal client or
traversal server zone.
Authenticated: <Yes/No>
Whether the search request should be treated as authenticated or not.
SourceAlias: <S: 0, 60>
The source alias to be used for the search request. Default: xcom-locate
Example: xCommand Locate Alias: "john.smith@example.com" HopCount: 15 Protocol: SIP
SourceZone: LocalZone Authenticated: Yes SourceAlias: alice@example.com
OptionKeyAdd
Adds a new option key to the VCS. These are added to the VCS in order to add extra functionality, such as
increasing the VCS's capacity. Contact your Cisco representative for further information.
Key(r): <S: 0, 90>
Specifies the option key of your software option.
Example: xCommand OptionKeyAdd Key: "1X4757T5-1-60BAD5CD"
Cisco VCS Administrator Guide (X7.1)
Reference material
Page 445 of 479