Cisco TelePresence Administrator's Manual page 250

Field Description
FindMe mode Determines whether or not FindMe is enabled,
and if a third-party manager is to be used.
Off: disables FindMe.
On: enables FindMe and uses the VCS's local
FindMe manager.
Remote service: enables FindMe and uses a
FindMe manager located on an off-box system.
This feature is intended for advanced
deployments with third-party integrators.
Caller ID Only applies when FindMe mode is On.
Determines how the source of an incoming call
is presented to the callee.
Incoming ID: displays the address of the
endpoint from which the call was placed.
FindMe ID: displays the FindMe ID associated
with the originating endpoint's address.
Restrict users Controls if users are restricted from adding,
from deleting or modifying their own devices. The
configuring default is Off.
their devices
Cisco VCS Administrator Guide (X7.1)
Usage tips
Call Policy is always applied regardless of
the FindMe mode.
If you enable FindMe, you must ensure a
Cluster name is specified (you do this on the
Clustering page).
Note that FindMe mode is automatically set to
On when the Starter Pack option key is
installed.
Using FindMe ID means that if the recipient
subsequently returns that call, all the devices
associated with that FindMe account will be
called. For H.323 calls placed through an
ISDN gateway, the E.164 Phone number
associated with the FindMe account is
signaled instead as that is a more appropriate
number to dial when returning the call. Note
that the ISDN gateway must be registered to
the same VCS as the call recipient.
The FindMe ID is only displayed if the source
endpoint has been authenticated (or treated
as authenticated). If it is not authenticated the
Incoming ID is displayed. See
authentication for more details.
By default FindMe users are allowed to
configure further devices in addition to any
principal or provisioned devices assigned to
them by the system administrator. This setting
can be used to stop users from adding their
own devices and restrict them to being able to
only maintain their locations and their
associated devices.
This setting does not apply if users configure
their FindMe settings via TMS (when VCS
and TMS are running in TMS Provisioning
Extension mode).
Applications
About device
Page 250 of 479