Cisco TelePresence Administrator's Manual page 385

Reference material
Administration MaxConcurrentSessions Total: <0..10000>
The maximum number of concurrent administrator sessions allowed on the VCS. This includes web, SSH, Telnet
and serial sessions. A value of 0 turns session limits off.
Default: 0
Example: xConfiguration Administration MaxConcurrentSessions Total:2
Administration SSH Mode: <On/Off>
Determines whether the VCS can be accessed via SSH and SCP. You must restart the system for any changes to
take effect.
Default: On
Example: xConfiguration Administration SSH Mode: On
Administration Telnet Mode: <On/Off>
Determines whether the VCS can be accessed via Telnet. You must restart the system for any changes to take
effect.
Default: Off
Example: xConfiguration Administration Telnet Mode: Off
Administration TimeOut: <0..10000>
Sets the number of minutes that an administration session (serial port, HTTPS, Telnet or SSH) may be inactive
before the session is timed out. A value of 0 turns session time outs off.
Default: 30
Example: xConfiguration Administration TimeOut: 0
Alternates Cluster Name: <S: 0,128>
The fully qualified domain name used in SRV records that address this VCS cluster, for example
"cluster1.example.com". The name can only contain letters, digits, hyphens and underscores.
Warning: if you change the cluster name after any user accounts have been configured on this VCS, you may
need to reconfigure your user accounts to use the new cluster name. Refer to the Clustering and peers section
for more information.
Example: xConfiguration Alternates Cluster Name: "Regional"
Alternates ConfigurationMaster: <1..6>
Specifies which peer in this cluster is the master, from which configuration will be replicated to all other peers. A
cluster consists of up to 6 peers, including the local VCS.
Example: xConfiguration Alternates ConfigurationMaster: 1
Alternates Peer [1..6] Address: <S: 0, 128>
Specifies the IP address of one of the peers in the cluster to which this VCS belongs. A cluster consists of up to 6
peers, including the local VCS. This must be a valid IPv4 or IPv6 address.
Example: xConfiguration Alternates 1 Peer Address: "10.13.0.2"
Applications ConferenceFactory Alias: <S:0,60>
The alias that will be dialed by the endpoints when the Multiway feature is activated. This must be pre-configured
on all endpoints that may be used to initiate the Multiway feature.
Example: xConfiguration Applications ConferenceFactory Alias: "multiway@example.com"
Cisco VCS Administrator Guide (X7.1) Page 385 of 479