TANDBERG Video Communication Server Administrator's Manual page 46

Grey Headline (continued)
Status
Event Description
License Limit Reached
Licensing limits for a given feature have been reached. The
field are:
•
•
If this occurs frequently, you may wish to contact your TANDBERG representative to purchase more licences.
Message Received
An incoming RAS message has been received.
Message Received
An incoming RAS NSM Keepalive, H.225 or H.245 message has been received.
Message Received
(SIP) An incoming message has been received.
Message Rejected
This could be for one of two reasons:
1.
2.
Message Sent
An outgoing RAS message has been sent.
Message Sent
An outgoing RAS NSM Keepalive, H.225 or H.245 message has been sent.
Message Sent
(SIP) An outgoing message has been sent.
Policy Change
A policy file has been updated.
Registration Accepted
A registration request has been accepted.
Registration Refresh
A request to refresh or keep a registration alive has been accepted.
Accepted
Registration Refresh
A request to refresh a registration has been rejected.
Rejected
Registration Refresh
A request to refresh or keep a registration alive has been received.
Requested
Registration Rejected
A registration request has been rejected. The
contain a textual representation of the H.225 additional cause code.
Overview and
Introduction Getting started
status
D14049.05
February 2009
Non Traversal Call Limit Reached
Traversal Call Limit Reached
The VCS Authentication mode is set to On, and an endpoint has unsuccessfully attempted to send a message (such as a registration request) to
the VCS. This could be either because the endpoint has not supplied any authentication credentials, or because its credentials do not match those
expected by the VCS.
Clustering is enabled but bandwidth across the cluster has not been configured identically, and the VCS has received a message relating to an
unknown peer, link, pipe, subzone or zone. Use TMS to synchronize configuration across peers.
System VCS
configuration configuration
Event Log
Detail
event parameter specifies the facility/limits concerned. Possible values for the detail
Reason
event parameter contains the H.225 cause code. Optionally, the
Zones and Call Bandwidth
neighbors processing control
46
TANDBERG VIDEO COMMUNICATIONS SERVER
Detail
event parameter may
Firewall
Applications Maintenance
traversal
ADMINISTRATOR GUIDE
Level
1
2
3
4
1
2
3
4
1
1
3
1
3
1
Appendices