TANDBERG Video Communication Server Administrator's Manual page 217

Grey Headline (continued)
Command reference - xConfiguration
Zones LocalZone Traversal H323 H46019 Demultiplexing Mode: <On/Off>
Determines whether the VCS will operate in Demultiplexing mode for calls from traversal-enabled endpoints registered directly with it.
On: allows use of the same two ports for all calls.
Off: Each call will use a separate pair of ports for media.
Default: Off
xConfiguration Zones LocalZone Traversal H323 H46019 Demultiplexing Mode: Off
Example:
Zones LocalZone Traversal H323 Preference: <Assent/H46018>
If an endpoint that is registered directly with the VCS supports both Assent and H460.18 protocols, this setting determines which the VCS uses.
Default: Assent
xConfiguration Zones LocalZone Traversal H323 Preference: Assent
Example:
Zones LocalZone Traversal H323 TCPProbe KeepAliveInterval: <1..65534>
Sets the interval (in seconds) with which a traversal-enabled endpoint registered directly with the VCS will send a TCP probe to the VCS once a call is established, in order to keep the
firewall's NAT bindings open.
Default: 20
xConfiguration Zones LocalZone Traversal H323 TCPProbe KeepAliveInterval: 20
Example:
Zones LocalZone Traversal H323 TCPProbe RetryCount: <1..65534>
Sets the number of times traversal-enabled endpoints registered directly with the VCS will attempt to send a TCP probe to the VCS.
Default: 5
xConfiguration Zones LocalZone Traversal H323 TCPProbe RetryCount: 5
Example:
Zones LocalZone Traversal H323 TCPProbe RetryInterval: <1..65534>
Sets the frequency (in seconds) with which traversal-enabled endpoints registered directly with the VCS will send a TCP probe to the VCS.
Default: 2
xConfiguration Zones LocalZone Traversal H323 TCPProbe RetryInterval: 2
Example:
Zones LocalZone Traversal H323 UDPProbe KeepAliveInterval: <1..65534>
Sets the interval (in seconds) with which a traversal-enabled endpoint registered directly with the VCS will send a UDP probe to the VCS once a call is established, in order to keep the
firewall's NAT bindings open.
Default: 20
xConfiguration Zones LocalZone Traversal H323 UDPProbe KeepAliveInterval: 20
Example:
Zones LocalZone Traversal H323 UDPProbe RetryCount: <1..65534>
Sets the number of times traversal-enabled endpoints registered directly with the VCS will attempt to send a UDP probe to the VCS.
Default: 5
xConfiguration Zones LocalZone Traversal H323 UDPProbe RetryCount: 5
Example:
Overview and
Introduction Getting started
status
D14049.05
February 2009
System VCS Zones and
configuration configuration neighbors
Call Bandwidth
processing control
217
TANDBERG VIDEO COMMUNICATIONS SERVER
Firewall
Applications Maintenance
traversal
ADMINISTRATOR GUIDE
Appendices