TANDBERG Video Communication Server Administrator's Manual page 199

Grey Headline (continued)
Command reference - xConfiguration
Call Services CallsToUnknownIPAddresses: <Off/Direct/Indirect>
Determines the way in which the VCS will attempt to call systems which are not registered with it or one of its neighbors.
Direct: Allows an endpoint to make a call to an unknown IP address without the VCS querying any neighbors. The call setup would occur just as it would if the far end were registered directly
to the local system.
Indirect: Upon receiving a call to an unknown IP address, the VCS will query its neighbors for the remote address and if permitted will route the call through the neighbor.
Off: Endpoints registered directly to the VCS may only call an IP address of a system also registered directly to that VCS.
Default: Indirect
xConfiguration Call Services CallsToUnknownIPAddresses: Indirect
Example:
Call Services Fallback Alias: <S: 0, 60>
Specifies the alias to which incoming calls are placed for calls where the IP address or domain name of the VCS has been given but no callee alias has been specified.
xConfiguration Call Services Fallback Alias: "reception@example.com"
Example:
Error Reports Mode: <On/Off>
Determines whether the VCS will automatically send details of application failures to a specified web service.
Note: You must restart the system for any changes to take effect.
Default: Off
xConfiguration Error Reports Mode: Off
Example:
Error Reports URL: <S: 0, 128>
The URL of the web service to which error reports are sent.
Default: http://vcser.tandberg.com/submitapplicationerror/
xConfiguration Error Reports URL: "http://vcser.tandberg.com/submitapplicationerror/"
Example:
Ethernet [1..2] IP V4 Address: <IPAddr>
Specifies the IPv4 address of the specified LAN port.
Note: You must restart the system for any changes to take effect.
Default: 192.168.0.100
xConfiguration Ethernet 1 IP V4 Address: "192.168.10.10"
Example:
Ethernet [1..2] IP V4 StaticNAT Address: <S:7..15>
If the VCS is operating in static NAT mode, this specifies the external public IPv4 address of that static NAT. Note: You must restart the system for any changes to take effect.
xConfiguration Ethernet 1 IP V4 StaticNAT Address: "64.22.64.85"
Example:
Ethernet [1..2] IP V4 StaticNAT Mode: <On/Off>
Specifies whether the VCS is located behind a static NAT. Note: You must restart the system for any changes to take effect.
Default: Off
xConfiguration Ethernet 1 IP V4 StaticNAT Mode: On
Example:
Overview and
Introduction Getting started
status
D14049.05
February 2009
System VCS Zones and
configuration configuration neighbors
Call Bandwidth
processing control
199
TANDBERG VIDEO COMMUNICATIONS SERVER
Firewall
Applications Maintenance
traversal
ADMINISTRATOR GUIDE
Appendices