Overview Of The Configuration Settings - Mobotix M22M Manual

34
/56
Always use Quick
Installation for initial
configuration
Admin Menu
User: admin
Password: meinsm
Setup Menu
Recommendation:
Always use factory image
settings!
M22M Camera Manual Part 1

3.2 Overview of the Configuration Settings

• Quickly installed using the Quick Installation wizard
After first booting the camera or after resetting it to factory defaults, any
access to the administration menu (Admin Menu button) will start the Quick
Installation.
This wizard will guide you through the most important settings of the camera
(configuration of the network interface, image control, etc.) and can also be
used to reset the camera to its factory settings.
It is recommended to use Admin Menu > Quick Installation later on as well,
e.g. if you would like to change or add connection methods.
• Administration and setup of the camera
Basic configuration tasks of the camera (e.g. passwords, interfaces, software
updates) are carried out from the administration menu (Admin Menu but-
ton), which requires the corresponding access rights ( admin access level).
Open the Setup Menu (button) and find the dialogs for changing the image,
event and recording settings in the Image Control and Event Control sec-
tions. These options are also available for users belonging to the users
access level.
Some of these settings can be changed using the corresponding pull-down
menus above the image on the Live screen.
• The image settings are already optimized
The factory image settings of the MOBOTIX camera deliver excellent images
for most of the application scenarios and should not be changed; if changes
are inevitable, the adjustments should be minimal. If you would like to reset
changes without resetting the complete configuration to factory defaults, you
can use the Factory button at the bottom of the dialog to reset only this dia-
log's settings. If you would like to reset all image settings, you may do so
using the Manage Settings > Restore Image Settings pull-down menu
above the image on the Live screen.
• All changes are only temporary
All changes to the configuration are only temporary and can thus be tested
easily. Restoring the old configuration settings can be achieved using the
Restore button in most dialogs or by running Admin Menu > Restore last
stored configuration from flash (see also section 5.9, Managing Settings , in
the Software Manual ).
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • sales@mobotix.com • 31.1.2007