Mounting The Camera With The On-Wall Set; Mounting Instructions - Mobotix D26 Dome Manual

Mounting the Camera with the On-Wall Set

2.3 Mounting the Camera with the On-Wall Set

2.3.1 Mounting Instructions

On-Wall Sets available in 0° and 10° inclinations allow the D26 to be installed quickly and easily
on the wall or ceiling of a room. When using the set outdoors (IP65), ensure that the screw
holes on the rear of the camera housing are sealed with the included foam rubber washers.
It is not possible to install the On-Wall Set directly above a surface- or flush-mounted socket.
The 10° On-Wall Set is the right choice if you want to mount the D26 on a wall with the lens
pointing vertically downward (90° or more). If the 10° On-Wall Set is not used, then the angle
of the lens may not exceed 80° for design-related reasons.
If the discreet appearance of the D26 is of particular importance, the In-Ceiling Set is ideal
for mounting the camera on ceilings or drywalls.
The network connection and drill holes must be prepared correctly before installing the
On-Wall Set (both indoors and outdoors):
• Network connection: You can use any one of the four openings in the On-Wall Set to
guide the cabling into the camera. The network cable must be fed through the opening
without a connector. An additional connector to connect to the camera cable is required.
Preparing the drill holes: Use the drilling template for the D26 On-Wall Set to mark
•
the exact position for drilling the anchor holes with regard to the camera position.
When using the On-Wall Set outdoors, ensure that the screw holes on the rear of the
camera housing are sealed with the foam rubber washers included in delivery (IP65).
Caution
41