Table of Contents
Advertisement
24
/56
The mount covers RJ45
wall outlets and conceals
the cabling
M22M Camera Manual Part 1
2.7 Mounting the MOBOTIX M22M to a Wall or Ceiling
The wall mount is large enough to mount the camera over a wall outlet (see sec-
tion 2.7.4, Mounting the Camera over Wall Outlets ).
In order to increase the tilt of the camera, turn the vertical tilt joint by 180 degrees or
shorten it.
Only use the supplied connection cables and make sure that the
supplied rubber plugs have been fitted to seal off both connectors.
Note that the camera must never be installed without properly
installed connection cables and rubber plugs!
Never use
screws with countersunk heads to fasten the mount, as
these screws will destroy the mount.
2.7.1 Mounting to a Wall
Before attempting to mount the cam-
era, make sure that you have found the
best camera position. It is important
that the camera's field of view is not
obstructed in any way.
Once the camera has been mounted to
the wall, you can fine-tune its position.
Using the integrated SecureFlex wall
mount, the camera can be turned hori-
zontally and tilted vertically.
When mounted to a wall, the camera can be turned/tilted as follows:
• horizontally: approx. 180°
• vertically: approx. 70°
2.7.2 Mounting to the Ceiling
Before attempting to mount the camera
to a ceiling, make sure that you have
found the best camera position. It is
important that the camera's field of
view is not obstructed in any way.
Once the camera has been mounted to
the ceiling, you can fine-tune its posi-
tion. Using the integrated SecureFlex
wall mount, the camera can be turned
horizontally and tilted vertically.
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
Caution
www.mobotix.com • sales@mobotix.com • 31.1.2007
Advertisement
Table of Contents
