A
CM35
Assign Trunk Route data to the trunk route
number (for OG route).
CM36
Specify the combination of trunk routes allow-
ing the Tandem connection.
CM71
Assign the System Speed Dialing memory area
used exclusively for DIT-Outside.
CM72
Set the stored number to the Memory Slot
number allocated by CM71.
CM41
When no release signal arrives on the IC trunk,
specify the timer for forced disconnection
when the called party does not answer.
END
Operating Procedure
The outside calling party dials the telephone number, as usual. The call is answered at a predetermined
station, within the CCIS network, by passing the Attendant Console.
DESCRIPTION
CHAPTER 3 SYSTEM DATA PROGRAMMING
•
Y=04
Answer Signal from Distant Office
(1)
00-63: Trunk Route No.
(2)
2: Arrive
•
Y=05
Release Signal from Distant Office
(1)
00-63: Trunk Route No.
(2)
1 : Arrive
•
Y=00
(1)
XX ZZ
XX: 00-63 (Incoming Trunk Route)
ZZ : 00-63 (Outgoing Trunk Route for
(2)
0: Allow
(1)
66: Exclusive for DIT-Outside
(2)
XXX YYY
XXX: 000-299 (Starting Memory Slot No.
YYY: 001-300 (No. of Slots to be
NONE : No data
•
Y=0
(1)
000-299: Memory Slot No.
(2)
XXXX
XXXX : Access Code (Maximum 4 digits)
,
YY...Y : Calling Party's No.
•
Y=0
(1)
55
(2)
01-13: 8-60 seconds (4 second increments)
If no data is set, the default setting is 20-24
seconds.
– 267 –
DIRECT-IN TERMINATION-CCIS
DATA
CCIS)
in Block)
assigned in Block)
,
YY...Y
: Separator Mark
(Maximum 26 digits)
NWA-008853-001 Rev.3.0
JANUARY/31/2006
97ch3004.fm