NEC NEAX 2000 IPS System Manual page 118

A
CMA7 Assign a Destination Point Code (DPC) to
each CCH number.
NOTE: The Destination Point Code is used
to designate a terminating office in
the No. 7 CCIS network. Usually a
different DPC is assigned to each
CCH number in the same system.
Assign the Point Code of the Centralized Fault
Reporting office, if required.
Assign the originating office number to each
CCH number, if required.
NOTE: This data setting is required only for
open numbering system.
CMA8 Assign the CCH number to which a signaling
message is transferred according to the Point
Code received.
Up to 256 point codes can be assigned.
CMAA Select the CCH for CCIS.
Specify the type of the CCT card.
END
DESCRIPTION
CHAPTER 3 SYSTEM DATA PROGRAMMING
• Y=02
(1) 0-7: CCH No.
(2) 00001-16367: DPC
• Y=05
(1) 0-7: CCH No.
(2) 00001-16367: Point Code of Centralized
• Y=06
(1) 0-7: CCH No.
(2) 0000-9999: Office No.
(1) 00001-16367: DPC
(2) 0-7: CCH No.
• Y=14
(1) 04-15, 20-31: AP No. assigned by CM05
0 : PN-24CCTA/PN-30CCTA/PN-DTA
(2)
(Built-in CCH)
1 : PN-SC00 (CCH)
• Y=15
(1) 04-15, 20-31: AP No. assigned by CM05
0 : PN-30CCTA
(2)
1 : PN-24CCTA
– 104 –
DIGITAL CCIS PROGRAMMING
DATA
Fault Reporting office
Y=0
Y=0
NWA-008853-001 Rev.3.0
97ch3001.fm
JULY/01/2006