NEC NEAX 2000 IPS System Manual page 122

• For closed numbering system
START
CM20 Assign the access code for LCR Group 3.
When providing Centralized MAT or Network
Station Number (FCCS), assign the access
code for the number of digits of the network
station number.
NOTE:
For Centralized MAT or Number
Portability, this data must be set.
CM8A Assign an Area Code Development Pattern
number to the LCR Group selected above.
Assign a Route Pattern number to the digits to
be dialed in the Area Code Development Pat-
tern number assigned by CM8A Y=A000.
NOTE: The digits assigned in CM20 to
A129: LCR Group 3 must be entered
in the Area Code Development Pat-
tern table for access to the desired
Route Pattern number.
Assign an area code (station number) for intra-
office station, if required.
Specify the LCR selection priority for the
Route Pattern number assigned by CM8A
Y=4005-4007.
A
DESCRIPTION
CHAPTER 3 SYSTEM DATA PROGRAMMING
• Y=0-3 Numbering Plan Group 0-3
(1) X-XXXX: Access Code
(2) A129: LCR Group 3
• Y=0-3 Numbering Plan Group 0-3
(1) X-XXXX: Access Code
(2) 811-818: 1-8 digits network station No.
• Y=A000
(1) 0-3: LCR Group 3
(2) 4005-4007: Area Code Development Pat-
• Y=4005-4007 Area Code Development
(1) X-X---X: Area Code 1-8 digits
(2) 0000-0255: Route Pattern No. 000-255
• Y=4005-4007 Area Code Development
(1) X-X---X: Area Code 1-8 digits
(2) 8001-8008: 1-8 digits Intra-Office Station
• Y=0000-0255
Route Pattern No. 000-255
(1) 1: 1st priority
2: 2nd priority
3: 3rd priority
4: 4th priority
(2) XXX ZZ
XXX: 000-255: LCR Pattern No.
ZZ : 00-63: Trunk Route No.
– 108 –
DIGITAL CCIS PROGRAMMING
DATA
tern No. 5-7
pattern No. 5-7
Pattern No. 5-7
NWA-008853-001 Rev.3.0
97ch3001.fm