NEC NEAX 2000 IPS System Manual page 340

To provide an External TAS Indicator via the DK card:
START
CM10 Assign the DK card number to the required
LEN.
NOTE 1:
NOTE 2:
CM14 Assign the DK card to the required LEN.
[Series 3200 R6.2 software required]
NOTE 1:
CM44 Assign the TAS Group number assigned by
CM30 Y=17 to a circuit number on the DK
card.
NOTE:
A
DESCRIPTION
We recommend the setting of DK
card number by CM14, when using
Series 3200 R6.2 software or later.
The DK card number must be as-
signed to the 1st LEN (Level 0) and
the 3rd LEN (Level 2) of each LT
slot.
The DK card number must be as-
signed to the 1st LEN (Level 0) and
the 3rd LEN (Level 2) of each LT
slot.
Built-in External Equipment Inter-
face is not available for External
TAS indicator connection.
CHAPTER 3 SYSTEM DATA PROGRAMMING
TRUNK ANSWER FROM ANY STATION-CCIS
(1) 000-763: LEN
(2) E800-E831 : DK Card No.
For PIM0/1 : E800-E807
For PIM2/3 : E808-E815
For PIM4/5 : E816-E823
For PIM6/7 : E824-E831
NOTE 3:
(1) XX ZZZ (LEN)
XX : 00-59: FP No.
ZZZ: 000-127: Port No.
(2) E800-E831: DK card No.
NONE : No data
For FP No.00: E800-E807
For FP No.01: E808-E815
For FP No.02: E816-E823
For FP No.03: E824-E831
NOTE 2:
(1) XX Y: Circuit No.
XX : 00-31: DK Card No. assigned by
Y : 0-3: Circuit No.
313 : Built-in External Equipment Interface
on MP card
(2) 13 XX
XX: 00-63 (TAS Group No. assigned by
– 326 –
DATA
Circuit No.03 of E831 is used for
built-in External Equipment In-
terface of MP card by setting
CM44.
Circuit No.03 of E831 is used for
built-in External Equipment In-
terface of MP card by setting
CM44.
CM10/CM14 E800-E831
CM30 Y=17)
NWA-008853-001 Rev.3.0
97ch3005.fm