Vanguard OHV V-Twin User Manual page 96


Fig. 76
NOTE: The inspection in Step 2 is performed after
the carburetor has been disassembled.
2. Inspect throttle shaft and choke shaft for wear
(3), Fig. 77. Replace if worn.
Fig. 77
Replace either shaft if worn.
Replace the carburetor if the body is worn or if either
shaft clearance exceeds 0.010" (0.25 mm) when a
new shaft is used.
Disassemble
1. Remove four screws and upper body (1),
Fig. 78. Do not damage emulsion tube (2) in
upper body.
Fig. 78
2. Remove and discard gasket.
‚
ƒ

‚
3. Remove float and inlet needle.
Fig. 79
If idle mixture screw is equipped with adjustment
limiter cap (9), use a pliers to remove it before
removing idle mixture screw (inset), Fig. 80.
4. Remove idle mixture screw (3) and spring (4),
Fig. 80.
5. Remove anti-afterfire solenoid (8), if equipped,
or plug (7) and washer (6).
6. Remove fixed main jet (5) using Screwdriver,
#19062.
„
ƒ
…
† ‡
Fig. 80
7. Remove pilot jet (10) using Screwdriver #19061,
Fig. 81.
Fig. 81
‰
ˆ
Š
95