Vanguard OHV V-Twin User Manual page 104

Fig. 110
18. Assemble inlet needle retainer (21) to inlet
needle (22). Assemble to float (23), Fig. 111.
19. Install float (23) and needle to upper carburetor
body. Insert hinge pin (24).
Fig. 111
20. Invert upper carburetor body as shown in
Fig. 112.
•
The float should be parallel (25) with
carburetor bowl mounting surface.
•
If not, use a small screw driver to bend tang
(26) and lower (27) or raise (28) the float
level as shown.
CAUTION: DO NOT press on float to adjust.
Fig. 112
21. Place new gasket (31) on lower carburetor body.
Make sure holes in body line up with holes in
gasket, Fig. 113.
22. Install upper carburetor body. Tighten screws
(30) securely.
23. Install pilot jet (29).
24. Install washer (34) and plug (35) or anti-afterfire
solenoid (33). Torque to 45 in. lbs. (5 Nm).
Fig. 113
103