Vanguard OHV V-Twin User Manual page 112

AVOID EYE INJURY!
• Wear eye protection when using com-
pressed air.
4. Use only compressed air (blowing in both
directions) to clean out all openings and
passages.
NOTE: Do not use wire, drills or other mechanical
devices to clean out metering holes or
passages.
Inspect Carburetor
Inspect all parts for wear, cracks, nicks and burrs.
Inspect float for leaks. Replace damaged or worn
parts.
Assemble Carburetor
Use new seals and gaskets when assembling
carburetor.
1. Assemble new seal and bushings to throttle
shaft. Insert into carburetor body.
NOTE: Install one throttle plate at a time. Check
throttle for freedom of operation before
installing other throttle plate.
R
Use LOCTITE 222 on screw threads.
2. Insert bushings and choke shaft into carburetor
body.
3. Install choke plate.
CAUTION
R
NOTE: Use LOCTITE 222 on screw threads.
4. Assemble inlet needle to float. Install float,
Fig. 133.
5. Assemble bowl gasket to groove in body.
NOTE: The tab on the float bowl gasket (1) goes in
the slot in the float bowl carburetor body (2).
‚

Fig. 133
6. Install the carburetor jets to the float bowl.
7. Install the float bowl assembly to the carburetor
body.
NOTE: The float hinge pin is not secured in the
hinge pin posts. Be sure the hinge pin
remains in the posts until the float bowl is
installed.
8. Assemble fuel solenoid to float bowl.
CAUTION: Do not damage the float bowl when
tightening the solenoid. Do not overtighten.
111