Vanguard OHV V-Twin User Manual page 108

NOTE: Parts containing rubber, such as seals,
O-rings, inlet needles, seats or pump
diaphragms should not be placed in
commercial carburetor cleaner.
Do not leave non-metallic parts (plastic,
nylon, Minlon,
carburetor cleaner more than 15 minutes.
AVOID EYE INJURY!
• Wear eye protection whenever using com-
pressed air to clean parts.
4. Use only compressed air (blowing in both
directions) to clean out all openings and
passages.
NOTE: Do not use wire, drills or other mechanical
devices to clean out metering holes or
passages.
Inspect Carburetor
Inspect all parts for wear, cracks, nicks and burrs.
Inspect float for leaks. Replace damaged parts.
Assemble Carburetor
When assembling carburetor, use new seals and
gaskets.
1. Assemble new seal (2) to throttle shaft and insert
into carburetor body, Fig. 123.
NOTE: Install one throttle plate (1) at a time. Check
throttle for freedom of operation before
installing other throttle plate.
R
Use LOCTITE 222 on screw threads.
etc.), in commercial
CAUTION

Fig. 123
2. Install cover plate (3) with new gasket, Fig. 124.
Fig. 124
3. Install nozzle body (4) with new gasket (5),
Fig. 125. Tighten screw securely.
Fig. 125
4. Assemble new seal (7) to choke shaft and insert
into carburetor body, Fig. 126.
5. Install choke plate (6).
R
NOTE: Use LOCTITE 222 on screw threads.
‚
ƒ
„
…
107