Remove Flywheel; Flywheel Nut - 290000, 300000, 540000, 610000; Flywheel Nut - 350000, 380000; Flywheel Nut - All Models Except Powerlinke - Vanguard OHV V-Twin User Manual


Fig. 13

Remove Flywheel

Flywheel Nut – Models 290000, 303000, 540000,
610000
1. Prevent the flywheel from turning with Flywheel
Strap Wrench, #19433 (5) around outer rim of fly-
wheel, Fig. 14.
2. Turn the flywheel nut COUNTERCLOCKWISE
(arrow) with a 1/2" breaker bar (4) and a 30 mm
socket to remove.
„
Fig. 14
Models 350000, 380000
1. Place Flywheel Holder #19321 (6) on fan
retainer with lugs of flywheel holder engaging
slots on the fan retainer, Fig. 15.
NOTE: If engine is equipped with rewind starter hub
remove starter hub screw first. Then remove
flywheel nut.
2. Turn the flywheel nut COUNTERCLOCKWISE
(arrow) with a 1/2" breaker bar (4) and a 30 mm
socket to remove
NOTE: Do not remove fan retainer and fan at
this time.
„
†
Flywheel – All Models EXCEPT Engines with
PowerLinkt
NOTE: See the special procedure at the end of this
section for flywheel removal on engines with
the PowerLinkt system.
1. Reinstall flywheel nut (2). Turn nut down flush
with top of threads, Fig. 16.
2. Install Flywheel Puller #19203 (1).
3. Tighten puller screws equally until flywheel
loosens.
…
• DO NOT strike the flywheel with a hard
object or a metal tool. This could cause the
flywheel to shatter in operation.
• Use approved flywheel removal tools.
Fig. 15
CAUTION
AVOID INJURY!

‚
Fig. 16
71