Vanguard OHV V-Twin User Manual page 87

Fig. 42
Replace either shaft if worn.
Replace the carburetor if the body is worn or if either
shaft clearance exceeds 0.010" (0.25 mm) when a
new shaft is used.
Disassemble
1. Remove anti-afterfire solenoid (2) or bowl screw
(1), washer and bowl (3), Fig. 43. Remove bowl
gasket (4).
„
ƒ
Fig. 43
2. Remove fixed main jet (7) using Screwdriver
#19061, Fig. 44.
3. Remove float (5) and inlet needle (6).
NOTE: Float hinge pin (8) is swaged on one end.
Drive hinge pin out from side opposite
swage.
86
‚
4. Remove emulsion tube (10), Fig. 45.
NOTE: If carburetor is equipped with solenoid,
5. Use a pliers to remove the idle mixture screw
6. Remove idle mixture screw (11) and spring (12).

7. Remove pilot jet (13).
‚
8. Remove two screws (18) and the throttle plate
†
Fig. 44
remove solenoid seat (9) first, then remove
emulsion tube.
‰
Š
Fig. 45
adjustment limiter cap (14) if equipped, Fig. 46.
Fig. 46
(17), Fig. 47.
…
‡
ˆ