Vanguard OHV V-Twin User Manual page 84

Fig. 30
13. Remove screw (25) and choke plate (24),
Fig. 31.
AVOID EYE INJURY!
• Carburetor body has a detent ball (19) and
spring (20) that keeps tension on choke shaft.
Wear eye protection.
• Use caution when removing shaft!
14. Remove E-ring (23), washer (22) choke shaft
and seal (21).
Fig. 31
15. Use a punch (26) to remove transitional hole
welch plug (27) from top of carburetor, Fig. 32.
CAUTION
Ô Ô Ô Ó Ó
Ô Ô Ô
Fig. 32
This completes the carburetor
procedure.
Clean Carburetor
1. Disassemble carburetor.
2. Remove and discard all old gaskets, seals and
sealing material.
AVOID INJURY!
• Wear suitable protection when using cleaners.
Follow instructions on container.
3. Use commercial carburetor cleaning solvents
(such as Briggs & Stratton Spray Cleaner, Part
#100041 or #100042) to clean carburetor parts
and body.
4. When cleaning non-metallic parts (plastic, ny-
lon, Minlon, etc.), do not leave in commercial
carburetor cleaner more than 15 minutes.
NOTE: Parts containing rubber, such as seals,
O-rings, inlet needles, seats or pump
diaphragms should never be placed in
commercial carburetor cleaner.
AVOID EYE INJURY!
• Wear eye protection whenever using com-
pressed air to clean parts.
5. Use only compressed air (blowing in both
directions) to clean out all openings and
passages.
Î Î Î Î Ô Ô Ô Ô Ô Ô Ô
Ô Ô Ô
Ô Ô Ô Ô Ô
disassembly
CAUTION
CAUTION
83