Pto Ball Bearing - Vanguard OHV V-Twin User Manual

Insert Bushing Driver #19349 into bearing from oil
seal side. Place a reference mark on driver to
indicate proper depth of bushing when installing new
bearing, as shown, Fig. 6.
Remove
The magneto bearing has a roll pin installed in the oil
gallery to prevent the bearing from turning.
1. Drive roll pin (2) into oil gallery using a 3/16"
punch (1), Fig. 10.
2. Place cylinder on Cylinder Support #19227 with
large opening facing bearing.
3. Press out bearing with Bushing Driver #19349.

‚
Fig. 10
Install
1. Place cylinder on Cylinder Support #19227 with
large opening facing bearing.
2. Align oil holes in bearing with oil holes in cylinder.
3. Press in new bearing to correct depth with
Bushing Driver #19349 (3), Fig. 11.
Fig. 11
4. Grind off the taper (5), approximately 1/8" (3
mm) (4), from one end of new roll pin as shown,
Fig. 12.
a. Quench pin in water periodically to prevent
loss of temper.
b. Remove all burrs and clean thoroughly.
5. Place TAPERED end of new roll pin in the
6. Use Roll Pin Driver #19344 to install new roll pin,
7. Use Cylinder Support #19227 and press oil seal

PTO Ball Bearing

Check
Ball bearings must rotate freely, Fig. 14. If any rough
spots are felt replace the ball bearing.
ƒ
„
Fig. 12
bearing oil hole.
Fig. 13. Drive in new roll pin until tool bottoms.
until flush with cylinder.
Fig. 13
• CAUTION: Crankcase cover bearings are
usually damaged during removal from the
crankcase. Do not re-use crankcase cover
bearings.
Fig. 14
…
153