Remove Carburetor And Intake Manifold; Vertical Crankshaft, All Models; Horizontal Crankshaft - All Models; Remove Control Bracket - Vanguard OHV V-Twin User Manual

Remove Carburetor and Intake Manifold

Vertical Crankshaft, All Models

1. Remove air cleaner assembly.
2. Remove two screws (2) and choke control
bracket, Fig. 9.
3. Disconnect choke link (1) from carburetor.
NOTE: If engine is equipped with anti-afterfire
solenoid, air cleaner bracket (3) must be
removed BEFORE removing carburetor,
Fig. 9.
ƒ
Fig. 9
4. Remove carburetor mounting screws (4) and
carburetor, Fig. 10.
„
Fig. 10
Horizontal Crankshaft – All Models
NOTE: Disconnect anti-afterfire solenoid wire from
equipment switch wire. Remove blower
housing.
1. Remove two screws and choke control bracket
(5), Fig. 11.
70
2. Disconnect choke link (1) from carburetor.
3. Disconnect fuel line at carburetor.
4. Disconnect governor link and spring (4) from
5. Disconnect governor link.

‚
6. Disconnect fuel line at carburetor.
7. Remove intake manifold and gaskets.

Remove Control Bracket

1. Remove governor control bracket (1), Fig. 12.
2. Remove valley cover (2) and cylinder shields (3).

Remove Armatures

1. Disconnect stop switch wires at armatures.
2. Remove armature screws and lift off armatures
retainer (3) and throttle lever (2).

…
Fig. 11

‚
ƒ
Fig. 12
(1), Fig. 13.
‚
ƒ
„