Install Armatures
1. Assemble armature to engine, Fig. 20.
2. Install ground wire onto tab terminal on
armatures.
NOTE: Mounting holes in armature are slotted.
Push armature away from flywheel (arrow)
as far as possible. Tighten either screw (4)
to hold armature in place.
3. Repeat for second armature.
4. Adjust armature air gap. See Section 1.
Fig. 20
Install Control Bracket
1. Install cylinder shields (4) and valley cover (1),
Fig. 21. Torque screws to 65 in. lbs. (7 Nm).
Fig. 21
2. Connect ground wire harness to stop switch
terminal.
3. Assemble governor lever (3) to governor shaft.
4. Install governor control bracket (2). Torque
Install Carburetor and Manifold
Vertical Crankshaft
Models 290700, 303700, 350700
Current style: Fig. 22
1. Assemble gaskets (1) and spacer (4) to
2. Assemble carburetor onto mounting studs.
Early style: Fig. 23
1. Insert carburetor mounting screws (5) through
2. Assemble carburetor to manifold.
Models 351700, 380700
1. Assemble gaskets (2) and spacer (1) to intake
DO NOT tighten nut at this time.
screws to 140 in. lbs. (16 Nm).
manifold. Make sure that locating pin (2) on
carburetor spacer fits in recess (3) in manifold.
Fig. 22
carburetor, gasket (1), spacer (4) and gasket (1).
a. Make sure that locating pin on carburetor
spacer (2) fits in recess in manifold (3).
b. Torque screws to 65 in. lbs. (7 Nm).
Fig. 23
manifold.
169