Vanguard OHV V-Twin User Manual page 90

NOTE: Use LOCTITE 222 on screw threads.
Fig. 53
12. Assemble inlet needle retainer (19) to inlet
needle (18). Assemble to float (17), Fig. 54.
13. Install float to carburetor body. Install float hinge
pin (20) with swaged end out.
NOTE: Float level is not adjustable.
Fig. 54
14. Install pilot jet (23), Fig. 55.
15. Install idle mixture screw (21) and spring (22).
NOTE: DO NOT tighten screw. DO NOT install
limiter cap at this time.
Fig. 55
16. Install emulsion tube (24), Fig. 56, using Screw-
driver #19062.
17. If carburetor is equipped with anti-afterfire
solenoid, install solenoid seat (25).
18. Install fixed main jet (26) using Screwdriver
#19061.
Fig. 56
19. Install bowl gasket (28), float bowl (27), washer
and screw (29) or anti-afterfire solenoid (30), if
equipped, Fig. 57.
20. Position bowl drain as shown. Torque screw or
solenoid to 45 in. lbs. (5 Nm).
Fig. 57
89