Universal Transmitter (El-4602) - Electronics Line iconnect Installation Manual

Appendix B: Transmitter Installation
Deleting the Dual Magnetic Contact/Universal Transmitter
To delete the EL-4601DZ from the system:
1. Set the system to Delete mode.
• Go to the main menu and select [9]>[1]>[1] (Programming > Devices > Zones).
• Select a zone and press '√ʹ
2. Press >12 > '√ʹ.
For dual configuration (Magnetic + Universal) both magnetic and universal zones will be deleted.
3. Open the detector and take out the battery.
4. Press the tamper switch. While the tamper switch is being pressed insert the battery.
5. Within five seconds open the tamper and close it again.
EL-4601DZ complies with EN-50131 2-6 Grade 2 Class II Power Supply Type C

Universal Transmitter (EL-4602)

The EL-4602 is a 2-Way universal transmitter that includes a single output for use in a wide range of wireless
applications. When batteries need replacing, the EL-4602 sends a low battery indication to the Control System.
Figure B- 17: EL-4602 (Cover Off)
Registration Procedure
The EL-4602 must identify itself to the iConnect
1. Set the system to registration mode.
• Go to the main menu and select [9]>[1]>[1] (Programming > Devices > Zones)
• Select a zone and press '√ʹ.
2. Open the transmitter housing by inserting a small screwdriver at the bottom of the unit between the front and back
cover and twist the screwdriver to release the cover.
3. Remove the divider separating the battery from the contacts on the battery holder. The transmitter will send a
transmission. If the transmission is successfully received by the system it will play a confirmation sound. If no
confirmation sound is heard send another transmission by pressing and releasing the tamper switch of the
device.
Due to the occurrence of voltage delay in lithium batteries that have been in storage, the
batteries may initially appear to be dead. In this case, leave the unit in Test mode for a few
minutes until the battery voltage level is stabilized
4. As soon as 'Save?' appears press '√ʹ.
Installation Procedure
After the transmitter has been registered mount the transmitter as follows:
Before permanently mounting the unit, test the transmitter from the exact mounting
position. If necessary, improve the position of the transmitter.
iConnect Installation Manual
1. Terminal Block
2. Antenna
3. Battery Holder
4. LED Indicator
5. Tamper Switch
6. Location of Wiring Knockout
7. PCB Release Tab
Control System as follows:
89