Electronics Line iconnect Installation Manual page 138

Flood
Flood zones are always active. When triggered, Flood zones generate a Water alarm. These zones are designed for use
with EL-4761 flood detectors.
Environmental
Environmental zones are always active. When triggered, these zones generate an Environmental alarm. These zones are
designed for applications that monitor environmental conditions such as temperature or humidity. If the Bell option is
enabled for Environmental zones, the system sounds trouble tones from the keypad. These tones are sounded until the
user presses on their keypad. Environmental alarms are not affected by the expiry of the siren cut-off.
No Motion
No Motion zones are used to monitor the activity of disabled or elderly people. If a No Motion zone has not been
triggered within a pre-defined period of time (0 to 72 hours), a No Motion event message is sent to the central station.
Arm/Disarm
The Arm/Disarm zone is a future option that is not available in the current firmware.
Crash and Smash
This zone type can be used in cases where the alarm system, is positioned at the entrance of the premises. If a burglar
breaks the door and smashes the alarm system, during the entry delay time and before a confirmed break-in event can
be sent, a suspected break-in alarm event is sent to the monitoring station.
Not Used
This zone type is a future option that is not available in the current firmware.
134
Appendix E: Zone Types
Event Group: Burglary
Event Group: Burglary
Event Group: Medical
Event Group: Not applicable
Event Group: Burglary
Event Group: Not applicable
iConnect Installation Manual