Vocal Message Dialer Event Options - Electronics Line iconnect Installation Manual

10 Communications
10.9.2. Restore Reporting
For each event group, you can determine whether restore messages will be sent.
To enable or disable restore reporting for an event group:
1. From the Programming menu, select Communications, Event Options [955].
2. Select an event group.
3. From the event group's sub-menu, select Report Restore [#2].
4. Select Enabled or Disabled.
10.9.3. Two-Way Audio
For Burglary, Fire and Medical event groups, there is an additional option that enables Two-Way Audio for that event
group – see p. 31, 5.2.2 TWA Alarm Reporting.
To enable/disable Two-Way Audio for an event group:
1. From the Programming menu, select Communications, Event Options [955].
2. Select an Event Group (Burglary, Fire or Medical).
3. Select TWA [#3].
4. Select Enabled or Disabled.

10.10. Vocal Message Dialer Event Options

Events reported using the Vocal Message Dialer are divided into event groups that correspond with the pre-recorded
event messages. This allows you to enable or disable the Vocal Message feature for a specific group of events. For
further information on this feature, see p. 57, 10.3 Vocal Message Dialer.
The vocal message event groups and their associated system events are as follows:
Burglary [#1]
o
Alarm from Zone (excluding Gas
and Environmental zones)
o
Zone Tamper
o
Tamper
o
Duress
Fire [#2]
o
Zone Fire Alarm
o
User Activated Fire Alarm
Panic [#3]
o
Zone Panic Alarm
o
User Activated Panic Alarm
Medical [#4]
o
Zone Medical Alarm
o
Zone Medical Alarm
o
User Activated Alarm
o
No Motion
iConnect Installation Manual
Arm [#6]
o
Full Arm
o
Part Arm
o
Perimeter Arm
Disarm [#7]
o
Disarm
o
Disarm after Alarm
Water [#8]
o
Zone Water Alarm (Flood)
65