Checking The Steering System; Checking The Gear Shift And Throttle Operation; Checking The Power Trim And Tilt System; Checking The Engine Start Switch And Engine Stop Lanyard Switch - Yamaha F80BETL Service Manual

c
WARNING
The shift/throttle cable joint must be
screwed in a minimum of 8.0 mm (0.31 in)
c.

Checking the steering system

1. Check the steering friction for proper
adjustment.
2. Check that the
smoothly.
3. Check that there is no interference with
wires or hoses when the outboard motor
is steered.
Checking the gear shift and throttle
operation
1. Check that the gear shift operates
smoothly when the remote control lever
is shifted from neutral to forward or
reverse.
2. Check that the throttle operates smoothly
when the remote control lever is shifted
from forward or reverse to the fully open
position a.
6D93G11
S69J3370
steering operates
S60C1200
N
F
a
Checking the power trim and tilt
system
1. Check that the outboard motor tilts up
and down smoothly when operating the
power trim and tilt unit.
2. Check that there is no abnormal noise
produced when the outboard motor is
tilted up or down.
3. Check that there is no interference with
wires or hoses when the tilted-up out-
board motor is steered.
4. Check that the trim meter points down
when the outboard motor is tilted all the
way down.
Checking the engine start switch and
engine stop lanyard switch
1. Check that the engine starts when the
engine start switch is turned to START.
2. Check that the engine turns off when the
engine start switch is turned to OFF.
Predelivery checks
R
a
S69J1210
S60V1070
1-8
1
2
3
4
5
6
7
8
9