Adjusting The Choke Solenoid; Adjusting The Throttle Link And The Throttle Cable Operation - Yamaha 200A Service Manual

3. Check that the accelerator cam 3 is
aligned with the centerline of the roller 4.
4. Loosen the throttle lever tightening screw
5 clockwise to make the accelerator cam
aligned with the centerline of the roller 4.
5. Tighten the throttle lever tightening screw
5 counterclockwise.
NOTE:
The throttle lever tightening screw 5 has left
hand threads.
6. Start the engine and adjust the engine idle
speed by turning the idle adjusting screw.
Engine idle speed : 675-725 r/min

Adjusting the choke solenoid

1. Remove the intake silencer.
2. Make sure that the choke valve is fully open.
3. Check that the choke solenoid face A is
between the marking B on the plunger.
Adjust the position of the choke solenoid if
necessary.
60H5E11
Adjusting the throttle link and the
throttle cable operation
NOTE:
Complete the ignition timing adjustment,
throttle valves synchronization, engine idle
speed adjustment, and carburetor pickup tim-
ing adjustment prior to the throttle link adjust-
ment.
1. Loosen the locknut 1 , remove the clip 2,
60H30390
and disconnect the throttle cable joint 3.
2. Adjust the length of the throttle cable joint
3 so that its hole is aligned with the set
pin on the magnet control lever.
The throttle cable joint must be screwed in
a minimum of 8.0mm (0.31in.) A.
60H30400
Control system
3
60H30410
60H30415
60H30420
3-16