Control System; Adjusting The Start-In-Gear Protection; Adjusting The Throttle Link Position; Adjusting The Throttle Cable (Mh, Wh) - Yamaha E40G Service Manual

CHK
ADJ

Control system

Adjusting the start-in-gear protec-
tion
1. Set the gear shift to the neutral position.
2. Loosen the lock nut 1, and then adjust
the start-in-gear protection adjusting nut
2 until the top of the plunger a aligns
with the centre of the hole in the starter
case b.
a
b

Adjusting the throttle link position

1. Check that the throttle link and throttle
pulley for smooth operation. Adjust if nec-
essary.
2. loosen the throttle arm adjusting screw
1.
3. Turn the throttle grip or remote control
lever in the fully opened position and
adjust the throttle arm 2 until its contacts
with the stopper.
4. Tighten the throttle arm adjusting screw
1.
3-5
Periodic checks and adjustments
2
1
6F630050
1
2
6F630080
Adjusting the throttle cable
(MH, WH)
NOTE:
Before adjusting the throttle cables, the throt-
tle stop screw should be properly adjusted.
1. Check the throttle cables for smooth
operation, looseness, fraying or damage.
Replace if necessary.
2. With the throttle grip in the fully opened
position, check that the stopper on the
pulley contact with the stopper on the
bracket. Adjust if necessary.
3. Loosen the locknut 1 and adjust the
throttle cable (open-side) 2 with the
adjusting nut 3 until the stopper 4 on
the pulley contact the stopper plate a on
the bracket, then tighten the locknut.
4
4. Turn the throttle grip to the fully closed
position.
5. Loosen the locknut 5 and adjust the
length of the throttle cable (close-side) 6
with the adjusting nut 7 until the stopper
8 on the pulley contact the stopper plate
b on the bracket, then tighten the lock-
nut.
b
8
a
3
2
1
6F630085
5
7
6
6F630090
6F65G11