Utility Function; Utility Execution - Mitsubishi Electric GT14 User Manual

9.

UTILITY FUNCTION

Utility is a function, which carries out connection of GOT and PLC, screen display and operation method settings,
program/data control and self-check etc.
For the utility function list, refer to the following.

9.1 Utility Execution

For utility execution, utility has to be displayed by installing BootOS and Standard monitor OS in the C drive (Flash
memory).
There are following three types for the installing Standard monitor OS methods.
1) GT Designer3 GOT
GT Designer3
SD card
2) GT Designer3 or
USB memory
GT Designer3
SD card
3) GOT or GOT
USB memory
*1 When installing the BootOS and standard monitor OS, standard monitor OS has to be installed in GOT in advance.
For the installation which uses GT Designer3, refer to the following.
For the installation which uses GOT, refer to the following.
9.2 Utility Function List
USB interface or
Ethernet interface or
*1
RS-232 interface
BootOS or Standard monitor OS installation
GOT
BootOS or Standard
OS file
monitor OS installation
write
Install the SD
card or USB
SD card or
memory in GOT
*1
USB memory
OS file BootOS or Standard
upload monitor OS installation
Install the SD
SD card or
card or USB
*1
USB memory
memory in GOT
GT Designer3 Version1 Screen Design Manual (Fundamentals)
16. INSTALLATION OF COREOS, BOOTOS AND STANDARD MONITOR OS
Installed directly from GT Designer3
When GOT is remote, installed easily
using the SD card or USB memory
Install OS from GOT to GOT using
SD card or USB memory
9. UTILITY FUNCTION
9.1 Utility Execution
9
10
11
12
13
14
15
16
9 - 1