Table of Contents
Advertisement
Assign Ethernet I/F
Several drivers are assigned to the same Ethernet interface. However, only one GOT IP address is assigned per
interface.
By changing the settings of one interface, the GOT IP address, GOT port No. download, default gateway and subnet
mask settings of other drivers, which are assigned to the same interface, are also changed.
POINT
POINT
POINT
Communication parameter setting by drawing software
Select [Common Settings]
parameters for each communication driver.
When changing the communication parameters after downloading project data, change the setting at
communication detail setting of GOT.
GT Designer3 Version1 Screen Design Manual (Fundamentals)
10. COMMUNICATION INTERFACE SETTING (COMMUNICATION SETTING)
1.
2.
3.
[Communication Settings] from GT Designer3 to enter the communication
Touch the [Assign Ethernet I/F] button in
Communication Setting.
Touch the driver display BOX of the communication
parameter to be set in Ethernet I/F assignment.
The screen switches to the [Communication Detail
setting] screen.
Set communication parameters from this screen.
For the setting change operation, refer to the
following.
9.3.3 Basic operation of settings change
10.2 Communication Detail Setting
9
10
11
12
13
14
15
16
10 - 9
Advertisement
Table of Contents
