Warning Indicators And Messages - Sony MICROMV DCR-IP5 Operating Instructions Manual

Digital video camera recorder
Table of Contents

Advertisement

Warning indicators and messages

If indicators and messages appear on the screen, check the following:
See the page in parentheses "( )" for more information.
Warning indicators
100-0001 Warning indicator as to file (DCR-
IP7/IP7BT only)
Slow flashing:
•The file is corrupted.
•The file is unreadable.
•You are trying to carry out the MEMORY
MIX function on a moving picture.
C:21:00 Self-diagnosis display (p. 166).
E The battery is dead or nearly dead
Slow flashing:
•The battery is nearly dead.
Depending on the operating conditions,
environment and battery condition, the E
indicator may flash, even if there are
approximately 5 to 10 minutes remaining.
Fast flashing:
•The battery is dead (p. 13).
% Moisture condensation has occurred*
Fast flashing:
•Eject the cassette, turn off your camcorder,
and leave it for about 1 hour with the cassette
compartment open (p. 175).
Warning indicator as to "Memory Stick"
(DCR-IP7/IP7BT only)*
Slow flashing:
•No "Memory Stick" is inserted.
Fast flashing:
•The "Memory Stick" is not readable with
your camcorder (p. 112).
•The image cannot be recorded on "Memory
Stick" (p. 128, 134).
Warning indicator as to "Memory Stick"
formatting (DCR-IP7/IP7BT only)*
Fast flashing:
•The "Memory Stick" data is corrupted.
•The "Memory Stick" is not formatted
correctly (p. 109).
100–0001
C:21:00
Q Warning indicator as to tape
Slow flashing:
•The tape is near the end.
•No tape is inserted.*
•The write-protect tab on the cassette is out
(red) (p. 19).*
Fast flashing:
•The tape has run out.*
Z You need to eject the cassette*
Slow flashing:
•The write-protect tab on the cassette is out
(red) (p. 19).
Fast flashing:
•Moisture condensation has occurred (p. 175).
•The tape has run out.
•The self-diagnosis display function is
activated (p. 166).
- The image is protected (DCR-IP7/IP7BT
only)*
Slow flashing:
•The image is protected (p. 155).
Warning indicator as to cassette
memory*
Slow flashing:
•Eject the cassette, and insert it again. Even
then the indicator flashes, the MICRO
cassette memory of the cassette may be
broken.
Fast flashing:
•The MICRO cassette memory of the
camcorder may be broken.
* You hear the melody or beep sound.
171

Advertisement

Table of Contents
loading

This manual is also suitable for:

Micromv dcr-ip7Micromv dcr-ip7bt

Table of Contents