Turn The Lamp Off - Christie Mirage HD User Manual

Section 4: Maintenance
4-6
Table 4.2. Lamp/Filter Replacement Kits
Projector Model Model Number
Mirage S+3K 38-DSP102-xx
104-012101-xx
Mirage HD3
Christie HD3K 104-025101-xx
Christie HD2Kc 104-026101-xx
38-DSP102-xx
Matrix S+2K
Matrix HD2 104-023101-xx
DLV1400-DX 38-DSP102-xx
104-017101-xx
DLV1920-DX
Christie DS+6K 38-DSP104-xx
38-DSP104-xx
Christie DS+5Kc
Christie HD6K 104-006101-xx
Christie HD5Kc 104-007101-xx
104-013101-xx
Mirage HD6
Matrix S+5K 38-DSP104-xx
Matrix HD4 104-016101-xx
38-DSP106-xx
Christie DS+8K
Christie HD8K 104-008101-xx
Christie HD7Kc 104-018101-xx
Mirage S+8K 38-DSP106-xx
Mirage HD8 104-014101-xx
Matrix HD7 104-024101-xx
A lamp should be replaced when it reaches its end of life or sooner if a noticeable
degradation in brightness occurs (typical in aging lamps). You can set the number of
hours you expect to log with the lamp before replacing it, by setting the Lamp Limit
in the Lamp menu. The LED's next to the built-in keypad will flash "LP" when lamp
time has expired. You can also enable a warning message to appear upon powering up
the projector that will indicate the lamp has reached the limit you set, by entering a
checkmark beside the Lamp Message option.
NOTE: The lamp mode you choose to run the projector in may have an impact on the
number of hours expected for the lamp.
Tools required: #2 Phillips screwdriver
Warnings
A qualified service technician must perform lamp replacement.
Cool the lamp completely and handle by the housing only.
Install the correct wattage lamp supplied by Christie (see above) and read the
Lamp Replacement procedure in its entirety before proceeding.
Do not touch the glass surface of the lamp. Fingerprints left on the surface can
lead to an intense accumulation of heat called a "hotspot", which could
potentially result in the lamp shattering. It is recommended you wear clean, lint-
free gloves and a face shield when working with the lamp.

1. TURN THE LAMP OFF

Press (power) to turn the lamp off. Allow the cooling fans to stop
automatically (within approximately five minutes) before proceeding with Step 2.
This wait period is also required to allow the lamp to sufficiently cool before
handling.
Lamp Type (Watts)
500W
1000W
1200W
Mirage S+/HD, Matrix S+/HD, Christie HD/DS/DW, DLV User's Manual
Lamp/Filter Kit Required
03-000832-51P
003-120118-01
03-900537-51P
03-900537-51P
03-000832-51P
003-120118-01
03-000832-51P
003-120118-01
03-000833-51P
03-000833-51P
003-120117-01
003-120117-01
03-000833-51P
003-120117-01
03-000833-51P
003-120117-01
03-000834-51P
003-120116-01
003-120116-01
03-000834-51P
003-120116-01
020-100001-04 Rev. 1 (12/07) - Software v1.6g or higher