Christie Mirage HD User Manual page 101

Mirage S+/HD, Matrix S+/HD, Christie HD/DS/DW, DLV User's Manual
020-100001-04 Rev. 1 (12/07) - Software v1.6g or higher
NOTE: System messages appear on-screen only if Display Error Messages has been
set to "Screen" or "All".
System Warnings
A system warning indicates that a system malfunction has been detected (see Status
LED Codes, below). A system warning message replaces any input signal message
and disappears when the input signal status changes. While the projector will remain
operational, the message indicates the presence of a potentially serious problem that
should be investigated. You can press
results you should reset the projector—power the projector down and up again with
the (power) key.
System Errors
A system error message indicates that a serious malfunction has been detected and
must be investigated as soon as possible (see Status LED Codes, below). The projector
will no longer operate and must be reset—power the projector down and up again
with the (power) key.
The Status LED Codes
If the status code display on the back of the projector shows one of the following
values, you have encountered a likely system error requiring the attention of a
qualified service technician (see System Warnings and System Errors, above).
Acknowledge and clear the error with
resetting the projector by powering it off and on again, cooling when necessary.
Consult Table 3.5 and contact your dealer if the problem persists.
The specific code number identifies the source of the error detected, and is
particularly useful in cases where the projector is far away. For example, the code
"27" means the lamp could not be turned on. Error codes for this projector are listed in
Table 3.5 below.
.
to remove the message, but for best
Exit Exit
from presentation level, or try
Exit Exit
Section 3: Operation
3-73